CELTO ACOUSTIQUE C2.20

Description

Specifications
• Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF) : 2x 1200W 8 ohms | 2x 2000W 4 ohms | 1x 4000W 8 ohms (Bridge)
• Overall gain : 35dB (50 times voltage)
• Sensitivity at 8 ohms : 0.775Vrms (0dBu)
• Signal to Noise Ratio (A weighted, 0 dB) : >110dB
• Frequency Response (-1dB) : 20~20000Hz
• Typical THD (half power, 1kHz, 8 ohms) : <0.1%
• Typical IMD (1kHz at 4:1, -20dB) : <0.3%
• Crosstalk (1kHz) : >65dB
• Slew Rate : >30V/us
• Input Impedance : 20 kΩ
• Damping factor (1kHz, 8 ohms) : >500
• Protections : Soft-Start, Short-Circuit, Over-Voltage, Over-Current, Over-Load, DC Output, Temperature
• Operating Voltage : 190~260VAC 50-60Hz
• Preamp : Low noise and low distortion circuit, PeakStop Opto-Limiter
• Power Supply (PSU) : Linear topology with toroidal transforner
• Output stage : Class TD (82% efficiency)
• Cooling : Front to back airflow, Temperature regulated fans, Copper heat-sink for maximum heat transfer
• Rear Panel : 2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link ,2 NEUTRIK Speakon NL4, 2 speaker Binding post terminals, Stereo / Parallel / Bridge switch, Ground / Lift switch, Magnetic Breaker, PowerCon 20A (Included)
• Speakon Wiring : SPK1 = 1+1- CH A / 2+2- | CH B SPK2 = 1+1- CH B / 2+2- Not Used