CELTO ACOUSTIQUE C2.6

Description

Specifications
– Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF) : 2x 400W 8 ohms | 2x 600W 4 ohms | 1x 1200W 8 ohms (Bridge)
– Overall gain : 35dB (50 times voltage)
– Sensitivity at 8 ohms : 0.775Vrms (0dBu)
– Signal to Noise Ratio (A weighted, 0 dB) : >110dB
– Frequency Response (-1dB) : 20~20000Hz
– Typical THD (half power, 1kHz, 8 ohms) : <0.1%
– Typical IMD (1kHz at 4:1, -20dB) : <0.3%
– Crosstalk (1kHz) : >65dB
– Slew Rate : >15V/us
– Input Impedance : 20 kΩ
– Damping factor (1kHz, 8 ohms) : >500
– Protections : Soft-Start, Short-Circuit, Over-Voltage, Over-Current, Over-Load, DC Output, Temperature
– Operating Voltage : 190~260VAC 50-60Hz
– Preamp : Low noise and low distortion circuit, PeakStop Opto-Limiter
– Power Supply (PSU) : Linear topology with toroidal transforner
– Output stage : 2-step Class H without cross-rail distortion (70% efficiency)
– Cooling : Front to back airflow, Temperature regulated fans, Copper heat-sink for maximum heat transfer
– Rear Panel : 2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link ,2 NEUTRIK Speakon NL4, 2 speaker Binding post terminals, Stereo / Parallel / Bridge switch, Ground / Lift switch, Magnetic Breaker, PowerCon 20A (Included)
– Speakon Wiring : SPK1 = 1+1- CH A / 2+2- | CH B SPK2 = 1+1- CH B / 2+2- Not Used
– Chassis : 19″ 2U height, 378mm total depth
– Weight Net / Gross : 14kg / 16kg